€209.95*
Available in 1 day, delivery time 1-3 days
Our coating
"Ceramic 5+" is a covalent surface coating, which was developed to
protect painted, foiled or powdered surfaces optimally and permanently. Like
all Fusionskin products, we have developed, produced and thoroughly tested the
sealant 100% in Germany!
Ceramic 5+ forms a wafer-thin anti-stick layer. This is extremely stain
resistant, resilient and hard. It also extremely deepens the gloss and
color of the paint surface.
Our products bond chemically (covalently) with the surface and lay over the
paint pores. After curing, they form a high-gloss protective layer. This very
simple way of surface optimization protects the paint from damage such as
oxidation, salt, acids and insects. This makes it virtually impossible for dirt
to adhere to the surface, which also makes cleaning extremely easy.
Even if you wash your vehicle only by hand, after some time corresponding signs
of wear (micro scratches) will appear. If your vehicle is sealed with our
Ceramic 5+, these are minimized and the paint surface is sustainably protected.
self-leveling, permanent barrier layer
chemically bonds to the treated substrate,
excellent corrosion protection
easy-to-clean properties (ETC coating)
Applies and bonds to the substrate on a molecular level
Permanent coating creates a glass-like barrier layer only a few µm thick
High chemical and mechanical resistance with high surface tension (hydrophobic
properties)
temperature resistance up to approx. 1000°C.
Self-leveling or microplanarization provides no adhesion for dirt particles
Permanent gloss and color intensifying effect
Durability 5 to 15 years
CERTIFIED ACCORDING TO: DIN EN ISO 9227, DIN EN ISO 6270-2, DIN EN ISO 16474-2,
DIN 50021
Preparation:
There must be an almost perfectly prepared and degreased (free of any polish
residues) paint / film surface. The ambient temperature should ideally be
between 20 and 30 degrees.
In general, the preparation process does not differ from conventional / known
coating substrates.
Application:
Important: NO multi-layer process possible.
The substrate, whether "Ceramic 3+" or "Ceramic 5+" is
applied sparingly and carefully with an application sponge or microfiber pad to
the surface to be sealed in a so-called cross motion. The corresponding
surfaces are first coated horizontally and then vertically. The amount of
substrate can be varied in the application - however, there must be no dripping
at the edges.
Finishing / rubbing off:
Ceramic 3+: service life 3-7 years / Ceramic 5+: service life 5-15 years
After approx. 2 - 4 minutes (at 20 degrees approx. 4 minutes, at 30 degrees
approx. 2 minutes), gently rub the freshly sealed area with a microfiber cloth
until a homogeneous surface is created (rub the sealant into the surface, so to
speak). Then wipe with a 2nd clean microfiber cloth. Do not mix up the cloths
in the repeat process (it is best to use different colored cloths).
Irregularities in the layer thickness can lead to a "rainbow effect"
on the surface and must be reworked immediately.
Please consult with a Fusion Skin expert again for Ceramic 5+.
Curing:
The vehicle should not be exposed to the environment for at least 12 hours
after sealing. Protect the sealant from physical influences for at least 7
days.
Login